Remote Control Sensor Connection; Aerial Connection - Sharp HT-CN300H Operation Manual

Caution:
Only the supplied speakers should be used with this unit.
Make sure to connect the speakers after unplugging the unit.
Do not mistake and , and right and left terminals of the speaker leads.
Do not let the bare speaker wires touch each other.
Do not stand or sit on the speakers. You may be injured.
Insert the speaker plug fully with the rising side facing up.
Hold the speaker plug when removing it from the unit. Pulling
the lead may cause breakage.

Remote control sensor connection

Connect the plug of the remote
control sensor and push the plug
cover until it clicks.
Plug
Removing the remote control sensor:
Push the upper and lower sides of the plug cover and take the
plug off the unit to disconnect the remote control sensor.
Caution:
Hold the connection plug of the remote control sensor when removing it from the
unit. Pulling the lead may cause breakage.
Make sure of the top and bottom of the plug when plugging in the remote control
sensor.

Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS
socket and position the FM aerial wire in the direc-
tion where the strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP sock-
et. Position the AM loop aerial for optimum recep-
tion. Place the AM loop aerial on a shelf, etc., or
attach it to a stand or a wall with screws (not sup-
plied).
Note:
Placing the aerial on the unit, or near the AC power lead or the remote sensor may
cause noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
Plug cover
External FM aerial:
Push
Use an external FM aerial if you require better reception. Consult your dealer.
Push
External FM aerial
< Assembling > < Attaching to the wall >
Wall
02/6/17 HT-CN300H_(E)2.fm
HT-CN300H
Screws
(not supplied)
9