Remote Control - Sharp HT-X15H Operation Manual

Remote control

HT-X15H
ENGLISH
Battery installation
Use 2 "AAA" size batteries (UM-4, R03, HP-16 or similar).
1 Remove the battery cover.
2 Insert the batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them toward the
battery terminals.
3 Replace the cover.
Precautions for battery use:
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if the system will not be used for long peri-
ods of time. This will prevent potential damage due to battery
leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Installing the batteries incorrectly may cause the system to mal-
function.
Battery removal:
Remove the battery cover. Push each battery toward the
terminal and take them out.
E-23
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic.
Periodically clean the transmitter on the remote control and the
sensor on the main unit with a soft cloth.
Exposing the sensor on the main unit to strong light may interfere
with operation. Change the lighting or the direction of the main
unit if this occurs.
Keep the remote control away from moisture, heat, shock, and
vibrations.
Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the main
unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now,
you can enjoy music.
The main unit is equipped with 2 remote sensors. Use them
according to the installation method as shown below.
Main unit
Remote sensors
0.2 m - 6 m
(8" - 20')
battery
05/6/7 HT-X15H(H)E3.fm TINSZA064SJZZ