Table of Contents
Advertisement
Remote control
■ Battery installation
1
Open the battery cover.
2
Insert the batteries according to the terminal indicated in
the battery compartment. When inserting or removing the
batteries, push them towards the (–) battery terminals.
3
Close the cover.
Caution:
● Replace all old batteries with new ones at the same
time.
● Do not mix old and new batteries.
● Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
● Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
● Installing the batteries incorrectly may cause the unit
to malfunction.
● Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
Notes concerning use:
● Replace the batteries if the operating distance is re-
duced or if the operation becomes erratic. Purchase 2
"AAA" size batteries (UM/SUM4, R3, HP-16 or similar).
● Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may in-
terfere with operation. Change the lighting or the direc-
tion of the unit.
● Keep the remote control away from moisture, heat,
shock, and vibrations.
■ Test of the remote control
The remote control can be used within the range shown below:
15°
20 cm 〜 6 m
30°
30°
15
°
Press the
remote control.
● On sound bar: The power turns on and the indicator
● On Subwoofer: The Power/Subwoofer link indicator
Notes:
The system will automatically power on if TV or similar
component which supports HDMI CEC, is turned on.
To set the sound bar to standby mode:
Press the
remote control. "GOOD BYE" appears on the display.
Notes:
● A slight audio delay after TV is turned ON does not
● "AQUOS speaker is enabled" message will be
● The first time the unit is plugged in it will enter standby
● To cancel the standby mode, perform the following
During standby mode, press and hold the ECO button on
Remote sensor
the remote control.
- Sound bar indication light turned off.
Notes:
● When turning on the power from Eco mode, it may take
● AQUOS LINK function does not work during Eco mode.
Caution:
● During Eco mode, very small power is consumed when
To cancel the Eco mode:
When the sound bar is turned off, press and hold the ECO
button on the remote.
- Sound bar indication lights up in red.
E-12
General control
Make sure to enable the HDMI CEC when making
HDMI connection. For details, refer to the opera-
tion manual of the TV.
■ To turn the power on
/ ON/STANDBY button on the sound bar or
lights off. "WELCOME" appears on the display.
turns blue.
/ ON/STANDBY button on the sound bar or
mean that the system is faulty. This is normal.
displayed if SHARP LCD TV does not detect HT-
C21DS1 during power on. However the message
"AQUOS audio with AQUOS LINK is enabled" will be
displayed soon as HT-C21DS1 is detected. These
messages may vary depending on TV model.
■ Eco mode (remote control)
mode (Eco mode off). Sound bar indicator turns red.
procedure.
some time until the power is turned on.
the power cord is connected.
Advertisement
Table of Contents
