Remote Control; Ac Power Connection - Sharp SD-PX15H Operation Manual

Remote control

" Battery installation
2
1 Open the battery cover.
2 Insert the supplied batteries
according to the direction in-
dicated in the battery com-
partment.
When inserting or removing the bat-
teries, push them towards the
tery terminals.
3 Close the cover.
Precautions for battery use:
! Replace all old batteries with new ones at the same time.
! Do not mix old and new batteries.
! Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
! Do not use rechargeable batteries (nickel-cadmium battery, etc.).
! Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
! Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
! Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
! Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
! Keep the remote control away from moisture, heat, shock, and vibrations.
" Test of the remote control
Point the remote control directly at the re-
mote sensor on the unit.
The remote control can be used
within the range shown on the
right.
Press the ON/STAND-BY button. Does
the power turn on? Now, you can enjoy
your system.
bat-
Remote sensor
0.2 m - 6 m
(8" - 20')

AC power connection

" Connecting the AC power lead
After checking all the connections have been made correctly, plug the AC power lead
of this unit into the AC socket.
Note:
Unplug the AC power lead from the wall socket if the unit will not be in use for a pro-
longed period of time.
" To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check if the power leads are plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Notes:
! After the unit enters the power stand-by mode, wait a few seconds to turn on
again.
! You can also use the ON/STAND-BY button on the remote control.
04/2/9 SD-PX15H_SEEG_E.fm
SD-PX15H
ENGLISH
Wall socket
(AC 230 V, 50 Hz)
E-16
TINSZA052AWZZ
D
F
S
V
I
N
P
E