Page 2
Honda accessory security system) : Memory status Note: This guide is only use to help you get acquainted to your new Honda Remote Engine Starter. You should always check the User’s Information Manual for more operating information and safety features.
Page 3
COMMAND Repeat step 1 to extend to 20 minutes. BUTTON NOTE • Note that you cannot return the remote engine starter system to the 10-minute mode after changing to the 20- START minute mode by operating the transmitter. BUTTON •...
Using the Remote Engine Starter Stopping the Engine Push the command button on the transmitter for 1 second or less, then push the stop button within 2 seconds. The transmitter emits a short beep, and sends a signal to stop the engine. When the engine stops, the OFF indicator is shown on the display.
Page 5
Using the Remote Engine Starter Checking Vehicle Status You can check the vehicle condition on the transmitter display by performing the following operation: • Push the command button 2 times on the transmitter for 1 second or less. NOTE: This function does not work when the ignition switch is in the ON (II) position.
About This Quick Start Guide: This Quick Start Guide has been prepared to help you get quickly acquainted with your new Honda Remote Engine Starter. However, this guide is not intended as a substitute for the User’s Information Manual. For a complete information on operating your Honda Remote Engine Starter, please refer to the User’s Information Manual.