Installation; Bench Mounting; Functional Description; Blade Guard - Makita LS1440 Instruction Manual

INSTALLATION

1
1. Handle latch
1
1. Bolt
FUNCTIONAL
DESCRIPTION

1. Blade guard

1. Blade guard
6

Bench mounting

When the tool is shipped, the handle is locked in the lowered position by the
002147
handle latch. Release the handle latch by lowering the handle slightly and turn
the handle latch to the released position.
This tool should be bolted with four bolts to a level and stable surface using the
003638
bolt holes provided in the tool's base. This will help prevent tipping and possi-
ble injury.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Blade guard
002149
When lowering the handle, the blade guard rises automatically. The guard is
spring loaded so it returns to its original position when the cut is completed
and the handle is raised. NEVER DEFEAT OR REMOVE THE BLADE GUARD
OR THE SPRING WHICH ATTACHES TO THE GUARD.
In the interest of your personal safety, always maintain the blade guard in good
condition. Any irregular operation of the blade guard should be corrected
1
immediately. Check to assure spring loaded return action of guard. NEVER
USE THE TOOL IF THE BLADE GUARD OR SPRING ARE DAMAGED,
FAULTY OR REMOVED. DOING SO IS HIGHLY DANGEROUS AND CAN
CAUSE SERIOUS PERSONAL INJURY.
If the see-through blade guard becomes dirty, or sawdust adheres to it in such
a way that the blade is no longer easily visible, unplug the saw and clean the
guard carefully with a damp cloth. Do not use solvents or any petroleum-based
cleaners on the plastic guard.
If the blade guard is especially dirty and vision through the guard is impaired,
001782
use the supplied socket wrench to loosen the hex bolt holding the center cover.
Loosen the hex bolt by turning it counterclockwise and raise the blade guard
and center cover. With the blade guard so positioned, cleaning can be more
completely and efficiently accomplished. When cleaning is complete, reverse
procedure above and secure bolt. Do not remove spring holding blade guard.
If guard becomes discolored through age or UV light exposure, contact a Mak-
1
ita service center for a new guard. DO NOT DEFEAT OR REMOVE GUARD.