Page 1
2 5 5 m m ( l O " ) MODEL 24016 3 5 5 m m ( 1 4 " ) MODEL LS1410 INSTRUCTION MANUAL Miter Saw & Standard Equipment Elbow (Dust Spout) Operating Handle (Switch) Locking Stopper Motor Housing...
Page 2
Is t h e miter clamp grip tightened firmly? B. Set t h e miter saw on a level bench, sturdy stand or table. If you intend t o use the tool in just one spot, fasten obtain a steady base for safe, sure cutting action.
Page 3
Loosen the miter clamp grip and place a square or triangular rule against the side of the guide fence and saw blade so as t o square the blade t o the fence. When this is done and you notice that the pointer on the miter angle indicator is not at zero on the miter scale, gently tighten the miter clamp grip and then loosen the t w o pan head screws holding t h e miter angle indicator plate.
Page 4
In this case, t h e saw blade is retracted after t h e blade stops, and t h e cut end will n o t be contacted by a spinning blade as in a regular saw.
Page 5
Saw Blades Chisel tooth combination saw blade F o r rip and cross-cut work. Most freauentlv used 2 5 5 - 7 2 6 0 Miter saw blade N o . 255 N-q. 2 5 5 - 4 2 5 5 - 4 A...