Honda 2000 RL Owner's Manual page 226

Main Menu Table of Contents
NUTS
BOLTS
8. Remove the two bolts and the
three nuts with a 7/16 in (10 mm)
wrench, then remove the engine
cover.
BLEEDER BOLT
9. Loosen the bleeder bolt on top of
the engine.
Pour coolant into the radiator up
to the base of the filler neck.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
Cooling System
Fill up to here
10.Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
11.Check the level in the radiator,
add coolant if needed.
Maintenance
FILLER NECK
CONTINUED