Troubleshooting - GE AIR Z09 IN EH Owner's Manual And Installation Instructions

Troubleshooting

If a malfunction occurs, check the following
before contacting your service center.
Problem
Indoor unit does not start immediately
when the air-conditioner is switched on
An unusual smell coming from the outlet
after the unit begins operating
A sound like water flowing can be heard
during operation
Mist is emitted during cooling mode
Creaking noise can be heard when the unit
starts or stops
The air conditioner does not operate at all
Cooling or heating efficiency is not good
The wireless remote controller does not
function
12
Troubleshooting
Once the air-conditioner is stopped, it will
not operate for approximately three
minutes while the refrigerant settles down.
This is usually temporary and caused by
odors concentrated in the air intake going
into the air conditioner. If it continues, turn
power off and contact your service center.
This is a normal sound caused by the
refrigerant flowing inside the unit.
This is normal. The conditioned air cools
down the room air rapidly and it sometimes
looks like fog.
This is a temporary phenomenon caused by
the deformation of plastic due to the
change in temperature. If it continues,
contact your service center.
Please check for the following:
1. Is a power connection loose?
2. Is the circuit breaker activated?
3. Is the voltage higher than 253 volts or
lower than 198 volts?
4. Is TIMER ON in operation?
1. Is the set temperature suitable?
2. Is the air inlet or outlet obstructed?
3. Are the air filters dirty or clogged?
4. Is the indoor fan speed set too low?
5. Is there another heat source in the room?
1. Is the remote controller unit out of range
(more than 8 meters from unit)?
2. Replace worn out batteries.
3. Are there any obstructions between the
wireless remote controller and the signal
receiver?