Switching Module Leds - Cisco Catalyst 4500e Series Installation Manual

Appendix D Module Overview and Specifications

Switching Module LEDs

Each switching module has one LED labeled STATUS that provides information about the module and
one numbered LED labeled LINK for each port on the module.
port and status LEDs.
switching module LEDs.
Figure D-5
WS-X4306-GB GIGABIT ETHERNET
1000BASE-X SWITCHING MODULE
Figure D-6
WS-X4148-RJ
Table D-3
LED
STATUS
LINK
Port
Status
OL-13972-01
Figure D-6
Gigabit Ethernet Port and Status LEDs
STATUS
1
10/100BASE-T Port LEDs
STATUS
Switching Module LEDs
Color/State Description
Indicates the results of a series of self-tests and
diagnostic tests performed by the switch.
Green All the tests pass.
Red A test other than an individual port test failed.
Orange System boot, self-test diagnostics running, or the
module is disabled.
1
Indicates the status of the 10BASE-T port.
Green The port is operational (a signal is detected).
Orange The link has been disabled by software.
Flashing The link has been disabled due to a hardware failure.
orange
Off No signal is detected.
Indicates individual port status.
2
Green The port is operational (a signal is detected).
Orange The link has been disabled by software.
shows the 10/100BASE-T port LEDs.
2 3
4 PORT
10/100 B
Catalyst 4500 E-Series Switches Installation Guide
Switching Modules
Figure D-5 shows the Gigabit Ethernet
Table D-3 describes the
D-7