Horizon Fitness E401 User Manual page 14

MON T H LY L O G SHEET S
M O NT H
WE E K # DISTA NCE
M O NT H LY T O TA L S :
M O NT H
WE E K # DISTA NCE
M O NT H LY T O TA L S :
M O NT H
WE E K # DISTA NCE
M O NT H LY T O TA L S :
2
E401_Rev.1.5.indd 26-27
MON T H LY G OA L
CA L O RI ES T I M E
MON T H LY G OA L
CA L O RI ES T I M E
MON T H LY G OA L
CA L O RI ES T I M E
TRO UBL ESH OOT ING
Your Horizon Series elliptical is designed to be reliable. However, if you do experience problems with your
elliptical, please reference the troubleshooting guide listed below.
PROBLEM:
The console does not turn on.
SOLUTION:
Verify the following:
• The outlet the machine is plugged into is functional. Double check that the breaker has not tripped.
• The correct adapter is being used. Only use the adapter provided or authorized by Horizon Fitness.
• The adapter is not pinched or damaged and is properly plugged into the outlet AND the machine.
• Unplug power cord. Remove the console and check that all connections to the console are secure and not damaged
or pinched.
NOTE: If your console uses batteries, they may need to be replaced.
PROBLEM:
The console turns on but the Time/RPM's do not count.
SOLUTION:
Verify the following:
• Unplug power cord. Remove the console and check that all connections to the console are secure and not damaged
or pinched.
• If doing the above does not fix the problem, the speed sensor and/or magnet may have become dislodged or
damaged.
PROBLEM:
The resistance levels seem to be incorrect, seeming too hard or too easy.
SOLUTION:
Verify the following:
• The correct adapter is being used. Only use the adapter provided or authorized by Horizon Fitness.
• Reset the console and allow the resistance to reset to the default position. Restart and retry the resistance levels.
PROBLEM:
The roller wheels appear to be leaving particles on the guide rails.
SOLUTION:
This is considered normal wear of the elliptical wheels.
To remove, simply wipe off the roller wheels and guide rails with a damp cloth.
PROBLEM:
The elliptical makes a squeaking or chirping noise.
SOLUTION:
Verify the following:
• The elliptical is on a level surface.
• Loosen all bolts attached during the assembly process, grease the threads, and tighten again.
2
2/29/08 10:05:46 AM