Sony STR-DA7100ES Service Manual page 2

STR-DA7100ES
Ver 1.2
Reference Power Output
(4 ohms 1 kHz, THD
0.7%):
2)
FRONT : 170 W + 170 W
2)
CENTER : 170 W
2)
SURR : 170 W + 170 W
SURR BACK
170 W
1)
Depending on the sound field settings and the
source, there may be no sound output.
2)
Measured under the following conditions:
Area code Power requirements
US, CND 120 V AC, 60 Hz
TW 110 V AC, 60 Hz
AEP 230 V AC, 50/60 Hz
KR 230 V AC, 60 Hz
CH 230 V AC, 50 Hz
Frequency response
PHONO RIAA equalization curve
0.5 dB
Power Amp Block 10 Hz – 50 kHz
3 dB (8 ohms)
Inputs (Analog)
PHONO Sensitivity: 2.5mV
Impedance: 50kohms
S/N: 86dB (A, 20 kHz
LPF)
MULTI CHANNEL Sensitivity: 150mV
INPUT1/2, SA-CD/CD, Impedance: 50kohms
TAPE, MD/DAT, DVD, S/N: 96dB (A, 20 kHz
TV/SAT, VIDEO1/2/3 LPF)
Inputs (Digital)
SA-CD/CD, DVD Impedance: 75ohms
(Coaxial) S/N: 96dB (A, 20 kHz
LPF)
SA-CD/CD, DVD, S/N: 96 dB
TV/SAT, MD/DAT, (A, 20 kHz LPF)
VIDEO 3 (Optical)
Outputs
TAPE, MD/DAT Voltage:150mV
(REC OUT), Impedance: 10kohms
VIDEO1/2 (AUDIO OUT)
FRONT L/R, CENTER, Voltage: 2V
SURROUND L/R, Impedance: 1kohms
SURROUND BACK L/R,
SUB WOOFER
EQUALIZER
Gain levels 10 dB, 1 dB step
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
2
FM tuner section
Tuning range
Antenna
Antenna terminals
Sensitivity
Mono:
2)
: 170 W +
Stereo:
Usable sensitivity 11.2 dBf, 1 V/75 ohms
S/N
Mono:
Stereo:
Harmonic distortion at 1 kHz
Mono:
Stereo:
Separation
Frequency response 30 Hz – 15 kHz, +0.5/–2
Selectivity
AM tuner section
Tuning range
Models of area code US, CND:
Models of other area codes:
Antenna
Usable sensitivity
S/N
Harmonic distortion 0.5% (50 mV/m, 400 Hz)
Selectivity
At 9 kHz:
At 10 kHz:
3)
You can change the AM tuning scale to either 9
kHz or 10 kHz. After tuning in any AM station,
turn off the receiver. While holding down PRESET
TUNING + or TUNING +, press ?/1. All preset
stations will be erased when you change the tuning
scale. To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure.
Video section
Inputs/Outputs
Video:
S-video:
COMPONENT VIDEO:
i.LINK section
87.5 - 108.0 MHz Pin
FM wire antenna Transmission speed S200 (Maximum data
75 ohms, unbalanced
Transmission protocol
18.3 dBf, 2.2 V/75 ohms
38.3 dBf, 22.5 V/75 ohms
Format (input)
76 dB
70 dB
0.3% * Conforms to the copy protection technology of
0.5%
45 dB at 1 kHz
General
Power requirements
dB
Area code
60 dB at 400 kHz
US, CND
AEP
TW
KR
3)
530 – 1,710 kHz
CH
(With 10-kHz tuning scale)
3)
531 – 1,710 kHz
Power consumption
(With 9-kHz tuning scale)
Area code
US, AEP, TW, KR,
531 – 1,602 kHz
CH
(With 9-kHz tuning scale)
CND
Loop antenna
Power consumption (during standby mode)
50 dB /m (at 1,000 kHz or
999 kHz)
AC outlets
54 dB (at 50 mV/m)
Area code
US, CND
AEP
35 dB
TW, KR, CH
40 dB
Dimensions
Mass (Approx.)
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
AC power cord (1)
Remote commander RM-AAE003 (1)
1 Vp-p, 75 ohms
LR6 (size-AA) batteries (3)
Y: 1 Vp-p, 75 ohms
Remote commander RM-US106A (1)
C: 0.286 Vp-p, 75 ohms
R6 (size-AA) batteries (2)
Y: 1 Vp-p, 75 ohms
Design and specifications are subject to
P /C /B-Y: 0.7 Vp-p, 75
B B
change without notice.
ohms
P /C /R-Y: 0.7 Vp-p, 75
R R
ohms
80 MHz HD Pass Through
(When PROGRESSIVE
OUT is set to "OFF")
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE
FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT
DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS
PUBLIÉS PAR SONY.
4 pins
transmission speed 200
Mbps)
A/M transmission protocol
Super Audio CD* (DSD
PLAIN)
2 channel linear PCM
(IEC-60958-3)
Sampling frequency: 44.1
kHz
DTLA (Revision 1.3).
Power requirements
120 V AC, 60 Hz
230 V AC, 50/60 Hz
110 V AC, 60 Hz
220 V AC, 60 Hz
220 V AC, 50 Hz
Power consumption
250 W
300 VA
1 W
AC outlets
2 switched, 120 W/1A MAX
1 switched, 100 W MAX
– (no AC outlet)
430 175 470 mm
5
(17 7 18 /
including projecting parts
and controls
23.5 kg (51 lb. 13 oz.)
Abbreviation
CH : Chinese model
CND : Canadian model
KR : Korean model
TW : Taiwan model
in.)
8