File Downloading; Table 16 Controller Downloading Summary - Honeywell UMC800 Installation And User Manual

Operation

File Downloading

File Downloading
Downloading configuration files, recipes and other files to the controller can be accomplished two ways:
1. Download from a PC or other device connected the Configuration port (serial port) of the controller.
2. Using the operator interface to download files stored on a floppy disk. These files include recipes,
setpoint profiles and data storage files.
There are mode restrictions on the downloading of certain configuration files. For example, the controller
must be in the Program mode before downloading a controller configuration file. (Program mode is set
using either the controller manual mode switch, the SET MODE display of the operator interface or issuing
a command to the controller through the Configuration port.)
Downloading recipe information and read/write of specific parameters is permitted when the controller is in
the Program mode, as well as the Run or Offline modes. See Table 16 for a file downloading summary.
Downloading . . .
Controller Configuration Files
Setpoint Profiles / Setpoint
Schedule
Recipe Files
Data Storage Configuration Files
Data Storage Non-volatile
parameters
Also, there are mode restrictions for these procedures . . .
Calibration
Real-time Clock Change
56

Table 16 Controller downloading summary

PROGRAM Mode
Yes
Yes
Yes
Yes
Yes
Yes
Yes
UMC800 Controller Installation and User Guide
Permitted When Controller is in . . .
RUN Mode
No
Yes
Yes
No
Yes
No
Yes
OFFLINE Mode
No
Yes
Yes
Yes
Yes
Yes
Yes
Release F
4/01