Mounting Thermostat - Honeywell DELUXEHEATPUMP T8511G Installation Instructions Manual

THERMOSTAT
O G B L C
O1
G1
B1
E1
CHANGEOVER
CONTROL
Fig. 3. Typical wiring diagram for T8511G with zone 1
MABS II control panel.
THERMOSTAT
B E L G Y R
W2 L G Y R
TotalZone® PANEL THERMOSTAT CONNECTIONS
1 WHEN USING W2 ON THE THERMOSTAT TO CONTROL THE SECOND
STAGE OF HEATING, BE SURE THE STAGE JUMPER IS IN PLACE ON
THE TZ PANEL.
Fig. 4. Typical wiring diagram for T8511G with zone 1
TotalZone® control panel.
FOR WRAPAROUND
INSERTION STRIP
7/16 IN. (11 MM).
Fig. 5. Proper wiring technique.
OUTDOOR
TEMPERATURE
SENSOR
R Y E W2 OT OT
ZONE 1
T8
T7
T6
T5
T4
M1
M12188
OUTDOOR
TEMPERATURE
SENSOR
(OPTIONAL)
1
O W2 C OT OT
W M6 M4 M1
FOR STRAIGHT
INSERTION STRIP
5/16 IN. (8 MM).
M4826
T8511G DELUXE HEAT PUMP ZONE THERMOSTAT

Mounting Thermostat

1. Engage tabs at the top of the thermostat and
wallplate. See Fig. 6.
2. Press lower edge of case to close and latch.
NOTE: To remove the thermostat from the wall, first pull out
at the bottom of the thermostat; remove top last.
A.
ENGAGE TABS AT TOP OF THERMOSTAT AND WALLPLATE.
B.
Fig. 6. Mounting thermostat on wallplate.
Using Thermostat Keys
The thermostat keys are used to:
• set temperature,
• display present setting,
M12189
• configure Installer Setup,
• check System-Test,
• display outdoor temperature (select models),
• set the system operation,
• set the fan operation.
See Fig. 7 for the location of the keys.
Fig. 7. Key locations and descriptions.
3
PRESS LOWER EDGE OF CASE TO LATCH.
INCREASE
TEMPERATURE
SETTING
DECREASE
i
TEMPERATURE
SETTING
DISPLAY PRESENT
SETTINGS AND SCROLL
THROUGH INSTALLER
SETUP MODES
(INFORMATION KEY)
M6798A
M6801
69-1052—1