Honeywell HRSD4 User Manual page 44

Configuration
6.
Caution
7.
8.
Setting the Date and Time Formats
1.
2.
3.
4.
44
The field beside Next Synchronization displays the time when the next
synchronization is scheduled.
Highlight Now... and press
If you select Now... and the time and date of the time server is
earlier than the last recorded image of the DVR, you will lose any
video with a later time and date.
Note When the time difference between the DVR and the time server is
more than one minute, the DVR might not synchronize the time
to prevent any unexpected loss of recorded video data. If you
want to synchronize the time manually, select Now....
A screen appears that allows you confirm this action. Select Yes
and press
Highlight the Run as Server field and press
When turned On, the DVR you are setting up runs as a time server.
Save your changes by highlighting OK and pressing
the screen without saving the changes.
Highlight the field beside Date Format in the Date/Time Setup screen, and press
. A list of date formats appears.
Highlight the format you wish to use and press
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD
Highlight the field beside Time Format in the Date/Time Setup screen, and press
to change the time format. The DVR toggles between 12 Hours (AM/PM)
and 24 Hours (military time).
Save your changes by highlighting OK and pressing
the screen without saving the changes.
if you want to synchronize the time instantly.
to continue.
to toggle between On and Off.
. The choices are:
. Select Cancel to exit
. Select Cancel to exit