Access Point Device Configuration In Codexml Mode - Honeywell FocusBT AP-010-BT Installation Manual

C
ONFIGURATION

Access Point Device Configuration in CodeXML Mode

When a scanner is using the CodeXML protocol all configuration data is stored in
the scanner. Since the data is not transmitted to the access point device, the
following process is required to configure the device for custom system formats
or protocol requirements.
To configure the access point device:
1. Verify a communication link is established between the scanner and
access point.
2. Scan the Disable CodeXML Protocol bar code.
Disable CodeXML Protocol
³ 1 2 5
3. Scan the Enable Metro Protocol bar code.
Enable Metro Protocol
³ 1 2 5
4. Scan all configuration bar codes required for the custom configuration (i.e.
keyboard type, country keyboard type, suffix or prefix settings).
Country keyboard bar codes are located on page 14. Additional
configuration bar codes can be found in the MetroSelect Single-
Line Configuration Guide (
Supplemental Configuration Guide (
5. Scan the Disable Metro Protocol bar code.
Disable Metro Protocol
³ 1 2 5
6. Scan the Enable CodeXML Protocol bar code.
Enable CodeXML Protocol
³ 1 2 5
† MetroSet2 (version 3.2.0.16 or higher) can also be used for access point
configuration if the device is connected to an RS232 com port or a USB
serial port.
P
ROCEDURES
6 0 7
6 1 4
6 0 4
6 1 7
x
00-02544 ) and the Area Imaging
PN
00-02281
PN
x
).
11