Usb Host Connections; Keyboard Wedge Host Connections; Rs485 Host Connections - Honeywell FocusBT AP-010-BT Installation Manual

I
NSTALLATION

USB Host Connections

1. Turn off power to the host system.
2. Plug the USB connector into the to
a dedicated USB serial port.
3. Turn on power to the host system.

Keyboard Wedge Host Connections

1. Turn off power to the host system.
2. Disconnect the keyboard from the
host system.
3. Connect the "Y" ends of the
communication cable to the
keyboard and the keyboard port on
the host system. If necessary, use
the male/female adapter cable
supplied with the device for proper
connections.
4. Turn on power to the host system.

RS485 Host Connections

1. Turn off power to the host system.
2. Connect the SDL connector into
a dedicated Port 9 on the host
system.
3. Plug the external power supply
into the power jack on the
PowerLink cable
Check the AC input requirements of the power supply verify the voltage
matches the AC outlet. The outlet must be located near the equipment.
See caution information on page 4.
4. Connect AC power to the transformer.
5. Turn on power to the host system.
Applicable for IBM
6 www.metrologic.com
®
Host applications.
Figure
7. USB Host Connections
Figure 8. KBW Host Connections
Figure 9. RS485 Host Connections