Resolved Caveats-Cisco Ios Xe Release 3.6(2)S - Cisco ASR 900 Series Release Notes

Chapter Restrictions and Caveats in Cisco IOS XE 3.6S Releases
Resolved Caveats—Cisco IOS XE Release 3.6(2)S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.6(2)S.
•
•
•
•
•
•
•
OL-26630-12
SFP insertion
–
Workaround: There is no workaround.
CSCtx00558
Symptoms: The standby RSP crashes during bootup.
Conditions: The issue can occur during bootup of a dual RSP system.
Workaround: There is no workaround.
CSCtx02522
Symptoms: The router displays intermittent traceback errors.
Conditions: Occurs when you configure REP.
Workaround: There is no workaround.
CSCty22165
Symptoms: The router displays the following console message: Transceiver initialization failed:
Unable to display idprom.
Conditions: The issue can occur when you perform an online insertion and removal (OIR) of an
OC-3 interface module.
Workaround: Perform a hard OIR (IM replacement) followed by a soft OIR (RSP switchover) on
the router.
CSCty42336
Symptoms: BFD sessions flap on the router.
Conditions: Occurs when the router is running IP BFD sessions in echo mode with 64 200ms X3
timers.
Workaround: There is no workaround.
CSCty57617
Symptoms: The router does not update IMA interface counters.
Conditions: Occurs after you perform an SSO on the router.
Workaround: There is no workaround.
CSCty74129
Symptoms: A REP topology may reconverge during an RSP switchover. The consoles displays REP
no-neighbor messages.
Conditions: Occurs when you configure REP between two Cisco ASR 903 Routers and you perform
an RSP switchover.
Workaround: There is no workaround.
CSCty77466
Symptoms: The port shaper rate changes on RSP switchover.
Conditions: Occurs under the following conditions: -You attach a shaper policy to an interface -The
interface is configured with multiple EVCs -The EVC has a QoS policy attached.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.6S Releases
9