Cisco ASR 900 Series Release Notes page 100

Asr 900 series
Hide thumbs Also See for ASR 900 Series:
Table of Contents

Advertisement

Caveats in Cisco IOS XE 3.7S Releases
Conditions: This issue occurs when soft OIR is performed.
Workaround: Do a hard OIR to get less than 50 msec loss.
CSCue73478
Symptom: The standby RSP Sync LED become holdover after switchover.
Conditions: This issue occurs in normal conditions,
Workaround: There is no workaround. This issue is cosmetic.
CSCue96886
Symptom: Complete MAC Address space is not available on the RSP.
Conditions: This issue occurs after removing the service instance with the MAC Addresses learnt
on the BD.
Workaround: Shutdown the service instance corresponding to bridge-domain and clear the
MAC-address-table of that bridge-domain. Remove the service instance.
CSCuf07508
Symptom: The Gigabit Ethernet port on IMA8S may not come up after reload.
Conditions: This issue occurs when the router is reloaded multiple times
Workaround: Perform an IM OIR.
CSCuf44077
Symptom: The show interface command output displays incorrect speed values after SSO.
Conditions: This issue occurs when 100M SFPs are used
Workaround: Perform hardware module reset.
CSCuf86247
Symptom: SNMP MIB variables related to BDI counters do not function properly.
Conditions: This issue occurs when SNMP MIB variables related to BDI interface counters are
used.
Workaround: There is no workaround.
CSCuh46103
Symptom: The BDI statistics not getting incremented.
Conditions: This issue is observed when the show interface bdi statistics command is executed.
The ingress and egress statistics displayed do not get incremented even if the traffic is going through
the BDI interface.
Workaround: Use show platform hardware pp active interface statistics bdi command to view
the statistics.
CSCuh65489
Symptom: The BGP session goes down when ICMP echo-request of 1500 pps is received.
Conditions: This issue occurs when the router has BGP peers and receives the ICMP-echo request.
The BGP hold timer expires nd BGP peer goes down.
Workaround: There is no workaround.
CSCuh79730
Symptom: The transmitting frequency is incorrectly displayed in case of DWDM-XFP-C.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
12
Chapter
OL-26630-12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 903

Table of Contents