New Software Features In Cisco Ios Xe Release 3.10.1S - Cisco ASR 900 Series Release Notes

New Software Features in Cisco IOS XE Release 3.10.1S

New Software Features in Cisco IOS XE Release 3.10.1S
There are no new software features introduced for Cisco IOS XE Release 3.10.1.S.
New Software Features in Cisco IOS XE Release 3.10S
The following features are introduced in Cisco IOS Release 3.10S.
•
•
•
•
•
•
•
•
•
•
•
•
•
Access Circuit Redundancy
Access Circuit Redundancy (ACR) enables local switching for circuit emulation (CEM) interfaces by
creating a virtual CEM-ACR interface. All configuration changes made on the virtual CEM-ACR
interface are applied automatically on both the Working and Protect interfaces.
For more information see,
Access Switch Device Manager Template
The Switch Device Manager (SDM) templates are used to optimize system resources in the router to
support specific features, depending on how the router is used in the network. The SDM templates
allocate Ternary Content Addressable Memory (TCAM) resources to support different features.
SDM templates are supported only by the Metro Aggregation Services license.
Note
For more information see,
Router.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
4
Access Circuit Redundancy, page 6-4
Access Switch Device Manager Template, page 6-4
Auto-IP, page 6-5
BFD Debug Enhancement, page 6-5
Bidirectional Forwarding Detection Deterministic Hardware Offload, page 6-5
Broadcast and Multicast Suppression, page 6-5
IGMP Snooping, page 6-5
Licensing the OC-3 and OC-12 Interface Modules, page 6-6
Multichassis LACP, page 6-6
Pseudowire Group Switchover, page 6-6
Remote LFA FRR Protection for TDM and ATM Pseudowires, page 6-7
Remote LFA FRR and Labeled BGP PIC FRR Integration, page 6-8
VPLS over Remote LFA, page 6-9
Configuring Access Circuit Redundancy on the Cisco ASR 903
Configuring Access Switch Device Manager Template on the Cisco ASR 903
Chapter
Router.
OL-26630-12