Table of Contents
Advertisement
Main Menu
Table Of Contents
Lights
CONNECTOR
BULB SOCKET
BULB
WEATHER SEAL
1.
Open the hood.
If you need to change the high
beam headlight bulb on the driver's
side, remove the coolant reserve
tank from its holder by pulling it
straight up.
2.
Remove the electrical connector
from the bulb by squeezing the
connector to unlock the tab, then
slide the connector off the bulb.
180
3.
Remove the rubber weather seal
by pulling on the tab.
4.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb
socket.
5.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
2009 S2000
6.
Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
The pins on the base of the bulb
should fit in the holes in the
headlight assembly. Pivot the hold-
down wire back in place, and clip
the end into the slot.
7.
Install the rubber seal over the
back of the headlight assembly.
8.
Push the electrical connector onto
the new bulb. Turn on the
headlights to test the new bulb.
9.
(Driver's side)
Reinstall the coolant reserve tank.
Advertisement
Chapters
Table of Contents
