Power Trim And Tilt Unit Will Not Operate; Water Separator-Alert Is Activated After Leaving Port - Yamaha F200 Owner's Manual

4. When replacing a fuse other than the
main fuse or isolater fuse, remove the
fuse using the fuse puller. Install a spare
fuse of the proper amperage.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40982

Power trim and tilt unit will not operate

EWM02330
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard motor
can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
3. Tilt the outboard motor up manually to the
desired position, and then tighten the
manual valve screw by turning it clock-
wise.
Trouble Recovery
EMU44370
Water separator-alert is activated after
leaving port
EWM01500
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot
●
or running engine. Allow the engine to
cool.
There will be fuel in the fuel filter. Keep
●
away from sparks, cigarettes, flames or
other sources of ignition.
This procedure will allow some fuel to
●
spill. Catch fuel in a rag. Wipe up any
spilled fuel immediately.
The fuel filter must be reassembled
●
carefully with the O-ring, filter cup, and
hoses in place. Improper assembly or
replacement could result in a fuel leak,
which could result in a fire or explosion
hazard.
If the water separator-alert indicator blinks or
the buzzer sounds intermittently, perform the
following procedure.
TIP:
The buzzer sounds only when the remote
control lever is placed in neutral.
1
1. Water separator-alert indicator
1
ZMU06963
100