Husqvarna 42" Collection System Operator And Parts Manual page 9

5
INSTALLING CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two
bagger hood.
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts. Use the illustration
for hardware orientation.
4. Slide the flex trim over the support and bagger
edge.
Upper Chute
Support
ASSEMBLY
/ holes into
3
8
Upper Chute
Support
Bagger Inlet
Flex Trim
6
MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Lift and rotate cover to align the cover brackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
8063-047
7
INSTALLING CHUTES
1. Place middle chute over the top end of the blower
assembly. Stretch the chute latch on the blower
assembly up and onto the acorn nut on the middle
chute.
NOTE: The kit provides parts for both the 42" and
48". Use the shorter upper chute for a 42" collection
system. Use the longer upper chute for the 48"
collection system.
2. Slide the upper chute discharge end into the
hood inlet and fit the lower end over middle chute.
Secure middle chute to upper as in Step 1.
3. Rotate the chute so the opening is facing
downwards toward the container bags.
8063-048
Chute Latch
8063-089
Middle Chute
8063-082
9