Husqvarna 42" Collection System Operator And Parts Manual page 6

1
BAGGER SUPPORT ASSEMBLY
Draw Bar A
1. Remove the upper bolts on each side of the
drawbar and replace them with the shoulder bolts
supplied with the collection kit.
NOTE: It may necessary on some models, to
remove the rear tires to access the drawbar
shoulder bolts.
Shoulder
Support Assembly
2. Hang the support assembly over the replacement
bolts and align the bottom pin into the drawbar.
Secure the bottom pin with a hairpin.
Hairpin
6
ASSEMBLY
Kit
Bolt
Drawbar A
Original
Shoulder
Bolt
Draw Bar B
1. Slide the flanges of the support assembly in the
slots in the drawbar.
Support Assembly
8063-083
2. Pivot the assembly backwards to insert the bottom
pin into the drawbar. Secure the bottom pin with a
hairpin.
8063-084
Hairpin
Drawbar B
8063-085
8063-086