Buffalo WCR-G300 User Manual page 39

Chapter 3 Configuration
Parameter
Wireless Radio
Wireless Channel
300 Mbps Mode
Broadcast SSID
SSID1
SSID2
SSID3
Separate feature
SSID
Authentication
WCR-G300 / WCR-HP-G300 User Manual
Meaning
Enable to allow wireless communication. If this is unchecked, then
no wireless connections will be allowed.
Sets a channel (a range of frequencies) used for wireless
connections. Available range of channels is 1-11.
With Auto Channel selected, the AirStation will automatically use
the best available channel.
This parameter is disabled if WDS is in use.
300 Mbps mode uses twice the normal frequency range, 40
MHz instead of 20 MHz. In uncongested areas this can increase
performance. To use 300 Mbps mode, set the Bandwidth to 40 MHz
and choose an Extension Channel.
Note: If using Auto Channel for the wireless channel, then the Extension
Channel is set automatically.
This parameter is disabled if WDS is in use.
If "Allow" is checked, then the AirStation will respond to SSID
searches from wireless devices by broadcasting its SSID. If "Allow" is
unchecked, then the AirStation ignore SSID searches from wireless
devices.
For Multi Security SSID1, wireless encryption must be set as No
encryption, WPA-PSK-AES, WPA2-PSK-AES, WPA/WPA2-Mixed or
WEP.
For Multi Security SSID2, wireless encryption must be set as No
encryption, WPA-PSK-AES, WPA2-PSK-AES, WPA/WPA2-Mixed or
WEP.
SSID3 can use WEP encryption.
When enabled, wireless devices connected to the AirStation can
communicate only with the Internet, not with each other.
This parameter does not function if WDS is enabled.
Set SSID using 1-32 alphanumeric character(s).
Specify the type of wireless authentication.
38