Buffalo WCR-G300 User Manual page 15

Chapter 2 Installation
5
Open the web configuration interface (page 71).
6
In the [Mode information] menu, select [Bridge Mode], then click [Apply].
7
8
The web configuration interface will open. Click [Wireless Config] , then [WDS].
9
Check [Use].
10
Follow the directions below.
AOSS / WPS Settings
Under Connection type, select AOSS or WPS and click the AOSS or WPS button. Also push the
AOSS or WPS button on the client device that you are connecting to the network. Automatic
configuration will take about a minute. To return the unit to its original IP address settings,
refer to Appendix D.
WCR-G300 / WCR-HP-G300 User Manual
When this below screen appears, re-enter
"admin" for the username and "password"
for the password and click [OK].
14