Wds Setup - Buffalo WCR-G300 User Manual

Chapter 2 Installation
7
Launch a web browser. If the [home] setup screen is displayed, setup is complete.
If a username and password screen are displayed, enter "admin" (in lower case) for the
username, leave the password blank, and click [OK]. Follow the instructions on the screen to
complete setup.
You've completed initial setup of your AirStation. Refer to Chapter 3 for advanced settings.

WDS Setup

To configure the WDS, follow the procedure below.
1
Change your computer's IP to a fixed address. For details, please refer to Appendix D (page 96).
ex) IP address
Subnet mask
Default gateway
Preferred DNS server
Alternate DNS server
2
Turn off your computer.
3
Connect your computer to one of the AirStation's LAN ports with the Ethenet cable.
Turn on the AirStation, wait one minute, and then turn on your computer.
4
Wait for about a minute, until the AirStation's LEDs are lit as described below:
Power
Wireless
Router
Diag
※ Refer to pages 8 and 10 for LED locations and other details.
WCR-G300 / WCR-HP-G300 User Manual
192.168.11.80
255.255.255.0
blank
blank
blank
Green LED on
Green LED on
Green LED on
Off
13