Select Site; Enabling A Dvr To Use Central User Management - Honeywell FUSION III DVR User Manual

Select Site

Enabling a DVR to Use Central User Management

________________________________________________________________________________________________________
Document 900.0803 Rev 8b
09/09
Defines the DVRs to which the user has access.
Click on the site to select it. Click the site again to deselect it.
Note Selected sites will be highlighted.
To enable a DVR to use the Central User Management software follow these steps:
Click the Administration tab in the Setup Window.
1.
Click the User Management button.
2.
Click the Authentication button.
3.
4. Enter the IP address of the Authentication Server running the Central User
Management software.
Enter the Server Port used by the Authentication Server. (Must be between 7000-
5.
7100)
6. Enter a Site Port that the DVR will use to communicate with the Authentication
Server. (Must be between 6000-6100)
Click Connect to save and close.
7.
Fusion III DVR User Guide
89