Modbus Command Group; Events Command Group - GE Digital Energy 1018959 Operating Manual

2.2.12 Modbus command group

The modbus command group controls the Modbus TCP slave functionality.
Command Parameters
modbus_key [key]
mb_tcp_enable on|off
mb_slave_id [id]
mb_tcp_port [port]
mb_float_enable on|off

2.2.13 Events command group

The events command group controls the alarm notification via traps and/or e-mail.
Command Parameters
showevents
event [row] [e-mail] [trap] [en]
NOTE: When the specific alarm handling is disabled, the alarm occurrence will be totally filtered – the
alarm will never appear active, it will not be reported by any mean and it will not be logged.
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Description
Enter the license key to enable Modbus TCP feature
[key] License key in GUID format
Note: Modbus TCP support requires a license key.
Refer to the Modbus section of this manual for details
Enable Modbus TCP slave
on Modbus TCP slave enabled
off Modbus TCP slave disabled
Set Modbus TCP Slave ID
[id] 1..247 = Set Modbus TCP Slave ID
255 = Disables Slave ID check
Set the Modbus TCP Port to be used
[port] TCP port to be used for Modbus TCP
Note: Default port for Modbus TCP is 502
Enable floating-point handling
on Floating-point handling enabled
off Floating point handling disabled
Note: A non-standard floating-point representation is
used – refer to the Modbus section of this manual for
details.
Description
Show the alarm notification configuration
Configure the alarm notification for a specific event
[row] Alarm ID
[e-mail] 0 = no e-mail notification for this alarm
1 = send e-mail on alarm (de)activation
[trap] 0 = no trap sent for this alarm
1 = send trap on alarm (de)activation
[en] 0 = alarm handling disabled
1 = alarm handling enabled
Page 25/69
Operating Manual SNMP/Web Adapter