Ups Command Group - GE Digital Energy 1018959 Operating Manual

2.2.10 UPS command group

The UPS command group allows monitoring and configuration of the managed UPS system.
Command Parameters
upsinfo (*)
upstest (*)
upscontrol (*)
upsconfig (*)
attacheddevice [device]
alarmdelay [time]
retrydelay [time]
retrycount [count]
serialbypass on | off
cardaddress [address]
ntp-ups on | off
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Description
Show detailed UPS information
Start/Stop UPS tests
Control the UPS (1-ph/SP versions ONLY)
Configure UPS parameters
Set UPS attached device
[device] Device which is powered/protected by the UPS
NOTE: Maximum length 63 chars. If this parameter contain
blanks or special characters it shall be specified in between
double quotation marks ("...")
Set alarm delay time (1-ph/SP version ONLY)
[time] Time in seconds before alarm notification
NOTE: This parameters is factory set to its ideal value and
shall not be changed unless instructed to do so
Set retry delay time (1-ph/SP version ONLY)
[time] Time in seconds between re-connection attempts
NOTE: This parameters is factory set to its ideal value and
shall not be changed unless instructed to do so
Set retry count (1-ph/SP version ONLY)
[count] Number of re-connection attempts
NOTE: This parameters is factory set to its ideal value and
shall not be changed unless instructed to do so
Enable/disable the serialbypass functionality
NOTE: This command is offered for UPS service access ONLY.
It use outside of this scope is not recommended (enabling
this functionality stops the UPS monitoring
Show/Set card address on the IMV bus
[address] Card address in the range 0, 54-57
NOTE: 3-ph version ONLY
This setting may overrides the HW setting through the dip-
switches on the card. Setting this parameter to 0 reverts to
the HW settings.
This setting becomes active only after reboot (save the
settings!)
Enable/disable the synchronization of the UPS time with an
external reference via NTP protocol.
NOTE: 3-ph version ONLY
Page 23/69
Operating Manual SNMP/Web Adapter