Cisco 2500 Series User Manual page 66

Status Windows
Table 3-26
Message
NTP: Failed to synchronize data & time with the
NTP server.
NTP: No NTP server specified.
NTP: Synchronization OK.
NTP: The NTP server cannot be reached.
output: Failed to set output port Port_Number.
output: Set output port Port_Number to high OK.
output: Set output port Port_Number to low OK.
output: Set output port Port_Number to pulse OK.
PTZ: Focus far.
PTZ: Focus near.
PTZ: Go to home.
PTZ: Go to Preset Position_Number.
PTZ: Move down.
PTZ: Move left.
PTZ: Move right.
PTZ: Move up.
PTZ: Zoom in.
PTZ: Zoom out.
Sensor: Change from Day mode to Night mode.
Sensor: Change from Night mode to Day mode.
SSH: Invalid SSH login attempt. [ip: Address]
SSH: SSH user logged in. [ip: Address]
SSH: SSH user logged out. [ip: Address]
Stream: HTTP stream started. [id: User, ip:
Address]
Stream: HTTP stream stopped. [id: User, ip:
Address]
Cisco Video Surveillance 2500 Series IP Camera User Guide
3-44
Syslog and Log Information (continued)
Chapter 3 Configuring and Managing the IP Camera
Explanation
Provides information when you configure the IP
camera to obtains its time from an NTP server.
Provides information when you configure the
output ports on the IP camera.
A user clicked the Focus Far button in the Home
window.
A user clicked the Focus Near button in the Home
window.
A user clicked the Move Camera Home button in
the Home window.
Provides information when you pan or tilt the IP
camera or it move it to a preset position.
The IP camera switched from day mode to night
mode.
The IP camera switched from night mode to day
mode.
A user attempted to log in to the IP camera through
SSH. Address is the IP address of the system that
was used.
A user logged in to the IP camera through SSH.
Address is the IP address of the system that was
used.
A user logged out of the IP camera through SSH.
Address is the IP address of the system that was
used.
Provides information when a user accesses (HTTP
stream started) or exits (HTTP stream stopped) the
Home window.
User is the IP camera user name of the user.
Address is the IP address of the PC that was used.
OL-19273-02