AS SE MB LY ST EP 3
HARDWARE BAG 3 CONTENTS :
10
CST3.5_Treadmill_Rev.1.0.indd 10-11
A Open HARDWARE BAG 3.
B Slide HANDLEBAR ExTENSION
onto the CONSOLE HANDLEBAR.
You will need to slide the
HANDLEBAR ExTENSION under
the console assembly plastic
by slightly lifting the plastic in
order to attach the connection
bolts.
C Insert BOLTS (E) into the
HANDLEBAR ExTENSION.
D Insert BOLT (F) and ARC
WASHER (D) through bottom
hole of HANDLEBAR ExTENSION
into CONSOLE MAST.
E Tighten all bolts.
F Repeat on other side.
ASSEMBLY STEP
HARDWARE BAG 2 CONTENTS :
SUPPORT BAR BOOTS
BOLTS (G)
MOUNTING
BRACKET
SUPPORT BARS
BOLTS (G)
POWER SWITCH
CIRCUIT BREAKER
YOU'RE FINISHED!
A Open HARDWARE BAG .
B Slide SUPPORT BARS into side
MOUNTING BRACKETS and
line up with top MOUNTING
BRACKETS.
C Insert 2 BOLTS (G) into the tops
and 2 BOLTS (G) into the bottoms
of each SUPPORT BAR.
D Slide SUPPORT BAR BOOTS down
to cover BOLTS (G).
E Connect power plug to the
treadmill and connect the cord to
a power outlet. The on/off switch
is located next to the power
cord. Flip this switch to the 'ON'
position, so that the switch is
lit. You will hear a beep and the
console will light up.
11
4/13/06 1:22:59 PM