Table of Contents
Advertisement
P R E- ASSE MBLY
DO NOT CUT STRAPS UNTIL STEP 1-E!*
WARNING
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
AS SE MB LY ST EP 1
HARDWARE BAG 1 CONTENTS :
BOLT A
* NOTE: If the straps have been removed before completing step 1-D and the linkage arms can not be aligned,
refer to the TROUBLESHOOTING section (page 28) in order to restore the treadmill to its proper position.
1
3
CST3.5_Treadmill_Rev.1.0.indd 8-9
Disassemble box and remove the
A
Open HARDWARE BAG 1.
B
Lift LEFT CONSOLE MAST into
upright position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it's own.
LEFT CONSOLE MAST
C
Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A)
and tighten.
D
Repeat on the right side.
E
Now cut the banding straps and
LEFT SIDE LINKAGE ARM
remove remaining packaging
material.*
F
Lift the RUNNING DECK until
lock latch on side of treadmill
is fully engaged.
G
Remove CONSOLE from box
and place out of the way.
H
Lower the treadmill RUNNING
DECK from the folded position
2
by stepping on LOCK LATCH on
lower right side.
ASSEMBLY STEP 2
HARDWARE BAG 2 CONTENTS :
* Be sure to tighten bolts after all are lined up.
* NOTE: Be careful not to pinch any
wires while assembling the masts.
A
Open HARDWARE BAG 2.
B
With running deck in lowered
position, place CONSOLE
on upright masts. Slide the
brackets that are underneath the
console into the top holes of the
upright masts.
C
Place LOCK WASHER (C) and
BOLT (B) into flat side of LEFT
upright MAST and lightly tighten.
D
Place ARC WASHER (D) and BOLT
(B) into curved side of LEFT
upright MAST and lightly tighten.
E
Gently lift RIGHT side of the
console to connect the CONSOLE
CABLE. Carefully tuck wires in
mast to avoid damage. Note: Do
not pinch console cable. Be sure
the console cable prongs are
aligned and the ends are tightly
seated into each other.
F
Repeat steps C-D above to
assemble the right side upright
mast and console.
G
Tighten all bolts completely.
4/13/06 1:22:57 PM
Advertisement
Table of Contents
