Sharp CD-SW250DVD Operation Manual page 120

Video CD playback (continued)
CD-SW250DVD
ENGLISH
To interrupt playback:
Press the 6 / STILL 60 button on the remote control.
To resume playback from the same point, press the 0 button.
To stop playback:
Press the H button.
To exchange to other disc whilst playing:
Press one of the s 1 - s 5 buttons of the stopped disc and within 5 seconds,
press the 7 OPEN/CLOSE button and exchange discs.
To remove the discs:
Whilst in the stop mode, press the s 1 - s 5 buttons and within 5 seconds,
press the 7 OPEN/CLOSE button.
Notes:
I Playback control allows a video CD to be played back according to
instructions recorded on the disc. The "previous", "next", "return" and "select"
operations may function differently, depending on the P.B.C. CDs.
I Some video CDs with playback control may have an "auto pause" recorded
on them. When such a disc is played, the screen will stop automatically at
the point where an "auto pause signal" has been inserted.
I If the picture looks dirty when a video CD is played back, there may be a
scratch on the video CD. Replace it with another video CD in good condition.
E-45
SW250DVD_43-46_EN+ 45
Caution:
I Do not place two discs in one disc tray.
I Do not play discs of special shapes (heart, octagon, etc.). It may cause
malfunctions.
I Do not push the disc tray whilst it is moving.
I Do not move the disc tray by hand. This may cause malfunctions.
I If the power fails whilst the tray is open, wait until the power is restored.
I If the disc tray is stopped with force, "ER-CD20" will appear on the display
for 3 seconds and the unit will not function. If this occurs, press the ON/
STAND-BY button to enter the power stand-by mode and then turn the
power on again.
I If TV or radio interference occurs during CD operation, move the unit away
from the TV or radio.
I If a disc is damaged, dirty, or loaded upside down, the disc will skip or not
play back.
To play without activating the playback control
H
function (Video CD with P.B.C. only)
You can play a video CD with P.B.C. without activating the playback control
function.
In this case, the menu screen will not appear, and the disc will be played in the
same way as a video CD without P.B.C.
I Default setting for VCD is P.B.C. OFF.
After finish VCD TOC reading, when play key is pressed it will
start play the VCD in P.B.C. OFF mode.
I To turn to P.B.C. ON mode, press TOP MENU button in remote control
whilst in stop or playback mode.
I "2 4 PRESET W" and "5 3 PRESET X" button is invalid during
STOP whilst VCD disc in P.B.C ON mode.
Notes:
I The P.B.C. function also can be cancelled whilst in the playback mode by
pressing TOP MENU button in remote control.
I Some video CDs with P.B.C. cannot be played back when the P.B.C. mode
is off.
27/4/05, 11:00 AM