An optical digital cable is not supplied.
Purchase an optional optical digital cable.
Optical digital lead
(not supplied)
Digital connection to a Dolby digital, DTS/MPEG
H
audio processor or MD recorder
You can record sound on a digital audio recorder by connecting to the digital
audio output socket using an optical digital cable.
When connecting a digital audio recorder to the digital audio output socket,
set the "
DIGITAL/MPEG" to "D-PCM/PCM" (see page 24).
BIT STREAM
For 5.1 channel Dolby Digital/DTS surround processors, etc.
D-PCM/PCM
For 2 channel digital input amplifiers, etc.
Note:
Some discs are copy protected and digital recording is not possible (including
DTS signals).
*DV999W_EP61-66
66
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.
Dolby digital, DTS/MPEG
audio processor or
MD recorder
General
H
To the digital
G The clock is not set to the
input socket
correct time.
G When a button is pressed,
the unit does not respond.
G No sound is heard.
Remote control
H
G The remote control does not
operate.
Symptom
Possible cause
G Did a power failure occur?
Reset the clock. (Refer to page 16.)
G Set this unit to the power stand-by mode
and then turn it back on.
G If the unit still malfunctions, reset it.
(Refer to page 68.)
G Is the volume level set to "0"?
G Are the headphones connected?
G Are the speaker wires disconnected?
G Is the Karaoke mode set to "L-CH", "R-
CH" or "V-CANCEL"?
Symptom
Possible cause
G Is the AC power lead of the unit plugged
in?
G Is the battery polarity correct?
G Are the batteries dead?
G Is the distance or angle incorrect?
G Does the remote control sensor receive
strong light?
04.3.4, 17:50
CD-DV999W (Z)
TINSZA017AWZZ
CD-DV999W
ENGLISH
4
E-66