Makita EG301A Instructions For Use Manual page 22

FULL POWER SWITCH (Except
Select the voltage using the FULL
POWER SWITCH in accordance with the
electrical appliance.
Refer to TABLE 2.
CAUTION
Change the FULL POWER SWITCH
after turning the
to "OFF".
Switch position
120V
120/240V
(1) CHECKING THE OPERATION
Overloaded ?
Please make it sure that the generator is not overload.
NOTE :
Most induction loads such as electric motors require three to five times more
wattage than their ratings during starting.
(2) STOPPING THE ENGINE
Turn off the switch of load.
Switch off generator's AC breaker.
Disconnect tool or appliance.
Turn the STOP SWITCH to the position "O" (OFF).
NOTE :
Allow the engine about 3 minutes to cool down at no-load before stopping.
EG301A)
AC circuit breaker
Lower Voltage Receptacle
Activated full rated output
Activated half of rated output
TABLE 2
1 2 0 V
Higher Voltage Receptacle
Activated full rated output
17
1 2 0 V
2 4 0 V
N.A