Makita 3710 Instruction Manual page 9

1
2
1. Screws
2. Wing bolt
3. Base
4. Screwdriver
1
2
1. Template guide
2. Base
3. Convex portions
1
2
3
4
10mm(3/8")
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
Remove the tool base from the tool. Loosen the wing bolts and secure the tool
006640
base horizontally. Loosen the two screws on the tool base.
3
4
Place the templet guide on the tool base. There are four convex portions on
006641
the templet guide. Secure two of the four convex portions using the two
screws. Install the tool base on the tool.
3
Secure the templet to the workpiece. Place the tool on the templet and move
001988
the tool with the templet guide sliding along the side of the templet.
6
NOTE:
• The workpiece will be cut a slightly different size from the templet. Allow
for the distance (X) between the router bit and the outside of the templet
guide. The distance (X) can be calculated by using the following
5
equation:
Distance (X) = (outside diameter of the templet guide - router bit diameter) / 2
Straight guide (Accessory)
006634
9