Makita 3710 Instruction Manual page 7

1
1. Switch lever
ASSEMBLY
1
2
3
1. Loosen
2. Tighten
3. Hold
1
2
1. Wing nut
2. Spring washer
3. Base
4. Trimmer shoe
5. Flat washer
6. Bolt
Switch action
006614
To start the tool, move the switch lever to the I (ON) position. To stop the tool,
move the switch lever to the O (OFF) position.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing trimmer bit
006629
CAUTION:
• Do not tighten the collet nut without inserting a bit, or the collet cone will
break.
• Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and tighten the collet nut securely
with the two wrenches.
To remove the bit, follow the installation procedure in reverse.
Installing trimmer shoe (after it has been removed from the tool)
006630
NOTE:
• The trimmer shoe is factory installed on the tool.
3
Use the bolts, wing nuts, spring washers and flat washers to install the trimmer
shoe as shown in the figure.
4
5
6
7