Honeywell Domonial User Manual page 9

The keypad confirms the code with a flashing red light,
- The audible confirmation
emitted by the sounder.
Always make sure that when arming the system it is followed by the audible confirmation.
Premises will be armed after you have closed the exit door (full set) or after 30 seconds (part set).
Your system is equipped with a TAG Reader, presenting the TAG in front of
the keypad can take the place of entering your code.
Presenting the TAG for more than 2 seconds will arm your system.
DISARMING VIA THE CODE KEYPAD
To enable you to get to the keypad without triggering an alarm, your installer has programmed an
entry delay of 30 seconds.
Enter your code or present the TAG for less than 1,5 seconds
A high-pitch beep confirms the entry of each digit,
The keypad confirms the validity of the code by a green light,
- The audible confirmation
emitted by the signaling equipment.
DISARMING THE SYSTEM AFTER AN ACTIVATION
If the red LED is illuminated on your alarm panel, this indicates an alarm has occured in one
zone only and the system will not operate until it has been reset.
0870 043 3920
18 9
is simultaneously
is simultaneously