Honeywell A-BUS Operation Manual page 7

2"
(5cm)
Deleting All Learned Keys in a Specific Mode
1. Press and hold "SETUP" until the LED blinks twice.
NOTE: If more than 10 seconds pass between key presses, the remote exits programming.
2. Press "976".
3. Press a device key twice (i.e., AMP, SAT, TNR, CD, AUX and DVD) to clear all the learned keys
for that mode. The LED blinks twice.
4. Repeat step 3 for another device key or press and hold "SETUP" to exit programming.
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace battery with two new AA alkaline batteries.
PROBLEM: LED blinks when you press a key, but device does not respond.
SOLUTION: Make sure the remote is aimed at your device and is not more than 15 feet
(4.5m) away.
PROBLEM: LED blinks one long blink.
SOLUTION: An entry error has occurred (for example, wrong key). Try entry sequence again.
PROBLEM: Remote does not control devices or commands are not working properly.
SOLUTION: Try all listed codes for the device. Make sure the device operates with an infrared
remote control.
PROBLEM: "CH+", "CH-", and LAST do not work for your RCA TV.
SOLUTION: Due to RCA's design from 1983 to 1987, only the original remote control will
operate these functions.
PROBLEM: No volume on a device.
SOLUTION: See "Changing Volume Lock"
PROBLEM: Channels do not change properly.
SOLUTION: If the original remote control required you to press Enter to change channel, press
Enter on this remote after entering the channel number.
6
Deleting a Single Learning Key
1. Press and hold "SETUP" until the LED flashes twice.
NOTE: If more that 10 seconds pass between key
presses, the remote exits programming.
2. Press "976".
3. Press the device key once (i.e., AMP, SAT, TNR, CD,
AUX and DVD).
4. Press the key containing the learned function to be
deleted twice. The remote LED blinks twice.
5. Repeat steps 2 through 4 for another key or press
and hold "SETUP" to exit programming
Using Learning
Troubleshooting