Using Learning - Honeywell A-BUS Operation Manual

A-BUS
Universal Remote
(cont...)
Clearing a Mode-Dependent Macro:
1. Press and hold "SETUP" until the red LED blinks twice, then release.
2. Press "978".
3. Press the device key where you programmed the macro (AMP, SAT, TNR, CD, AUX and DVD).
4. Press the macro's activation key.
5. Press and hold "SETUP" until the red LED blinks twice, then release.
The A-BUS™ Universal Remote includes a learning feature so you can add functions that are
unique to your home entertainment devices (e.g. VCR Tracking Up or Down).
However, there are some considerations:
Learning Precautions
• Your original remote controls must be in working order for Learning to work properly.
• Learned keys are mode specific, so each one can store a unique function for each mode.
• Learned keys can be used in macros (see Using Macros).
• Do not use the following keys for learning : Device Keys or SETUP Key.
• Learning capacity is approximately 16 to 25 keys, depending on the code being learned.
• Certain device codes are not learnable including multi-frequency types, some high frequency
ones, and other unusual formats.
• For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient
fluorescent lights.
NOTE: Please have your original remote controls handy before programming learning.
Programming a Learned Key
NOTE: If more than 10 seconds pass between key presses, the remote exits programming.
1. Press and hold "SETUP" until LED flashes twice.
2. Press "975".
3. Press a device key once (i.e., AMP, SAT, TNR, CD, AUX and DVD) to assign a mode for learning.
4. Place the A-BUS™ Universal Remote head-to-head about 2" (5cm) apart from original remote control.
Also locate the key (on your original remote control) that will serve as the teaching function.
5. On the A-BUS™ Universal Remote, press a key where the learned function will be stored.
6. On the original remote, press and hold the key to be learned. The A-BUS™ Universal Remote's
LED will turn off. Continue holding the key on the original remote until the A-BUS™ Universal
Remote's LED blinks twice.
NOTE: If the LED displays one long blink, a learning error has occurred. Try repeating this step
again until a successful capture occurs. If the function is still not captured, press and hold "SETUP"
to exit programming and review the "Learning Precautions" above. If needed, also see "Trouble-
shooting". After review, start programming again at step 1.
7. Repeat steps 2 through 6 for another device and/or key or press and hold "SETUP" to exit
programming.
System Design

Using Learning