System Design - Honeywell A-BUS Operation Manual

(cont...)
2. Enter "993" and then press the mode key for the device you want to control volume (for example,
AMP). The LED blinks twice. Now when you press "VOL+", "VOL-" or "MUTE", the selected
device (for example, AMP) will control the volume regardless of the current mode.
Unlocking All Volume Control (Restoring Global Unlock)
1. Press and hold "SETUP" until the red LED blinks twice, then release.
2. Enter "993" and then press "VOL+". The LED blinks four times. Volume is independently
controlled for all programmed devices.
Unlocking a Single Device's Volume Control
1. Press a device key (AMP, SAT, TNR, CD, AUX and DVD).
2. Press and hold "SETUP" until the red LED blinks twice, then release.
3. Enter "993" and then press "VOL-", The LED blinks four times. Volume is independently
controlled for the selected devices.
A macro can be used to control a home theatre operation, to set a favorite channel, or for other
multiple functions you would like to control with one key press. You can use any key to activate a
macro. Moreover, each Macro Key can hold up to 32 key presses.
You can program a macro that will operate regardless of what mode you are in, or one that will only
operate when you are in a specific mode.
NOTE: Programming a new macro over an existing one will erase the original macro.
Programming a Mode-Independent Macro:
1. Press and hold "SETUP" until the red LED blinks twice, then release.
2. Press "995". The LED will blink twice.
3. Press the key you want to use to activate your macro (Power, any unused key, etc.).
4. Enter the series of commands you want the macro to execute (up to 32 commands).
5. Press and hold "SETUP" until the red LED blinks twice, then release.
Now, when you press the Macro key, the remote will send the series of commands you have
entered, regardless of what mode you are in. For example, you could program the Macro key to
turn on both your TV and cable box and select a particular channel.
To clear the macro, repeat steps 1-5 above, but do not enter a series of commands at step 4.
Programming a Mode-Dependent Macro:
1. Press a device key (AMP, SAT, TNR, CD, AUX and DVD).
2. Press and hold "SETUP" until the red LED blinks twice.
3. Press "978". The LED will blink twice.
4. Press the key you want to use to activate your macro (Power, any unused key, etc.).
5. Enter the series of commands you want the macro to execute (up to 32 commands).
6. Press and hold "SETUP" until the red LED blinks twice, then release.
Now, when you press the Macro key, the remote will send the series of commands you have
entered, but only if you are in the mode you selected in step 1. For example, you could program the
Macro key to turn on both your TV and cable box and select a particular channel, but only if you are
in TV mode. If you are in DVD mode, this key will do nothing.
Changing The Volume Lock

System Design