Rip Fence; Miter Gauge - Grizzly G1023SL Instruction Manual

5. Moving the arbor bracket moves the V-belts
and pulleys out of alignment, so adjustment
of the motor pulley is required. Simply loosen
the setscrew in the middle motor groove pul-
ley and slowly slide the pulley towards the
end of the motor shaft. Once the V-belts are
back in alignment, tighten the setscrew
securely.
6. Reattach the table, making sure there is ade-
quate blade clearance through all blade
adjustments. Recheck guard alignment to
the blade and to the table top. Adjust as nec-
essary and tighten down all the bolts before
use.
7. If the blade is still contacting the insert,
repeat Steps 1-6. Check all other adjust-
ments.
8. Recheck the blade to miter slot adjustments,
and adjust as necessary.

Rip Fence

The rip fence included with your Model
G1023SL/G1023SLX Left-Tilting 10" Table Saw
is designed to provide excellent ripping accuracy
when properly adjusted. For complete adjustment
procedures, refer to the manual that is included
with the fence.

Miter Gauge

To adjust the miter gauge so it is perpendicu-
lar to the saw blade:
1. Loosen the lock knob on the miter gauge and
place a square against the face of the miter
body and the blade.
G1023SL/G1023SLX Left-Tilting 10'' Table Saw
2. Adjust the miter body until there is no space
between the square and the blade. Tighten
the lock knob.
3. With the stop link in the up position, loosen
the jam nut and adjust the stop screw until it
is seated against the stop link. See Figure
30 for part locations.
4. Now loosen the setscrew on the left front
side of the miter bar, adjust the pointer to 90°
and tighten the setscrew.
5. To adjust to 45°, follow Steps 1-4 using an
adjustable square set to 45°.
6. After rotating the miter body from 45° to 90°
and back a few times, double-check your
adjustments at both angles to assure that
you have accurately set your miter gauge.
The miter bar can be adjusted so that it fits tighter
in the miter slot. To do this, turn the adjustment
setscrew shown in Figure 30 clockwise. Turn the
adjustment setscrew in small increments at a
time so you do not over-adjust the miter bar.
Pointer
Stop Link
Figure 30. Miter gauge diagram
Jam Nut
Adjustment
Stop Screw Setscrew
Setscrew
-25-