Section 4: Operations; Operation Safety; Basic Controls - Grizzly EXTREME G0605X Owner's Manual

SECTION 4: OPERATIONS

Operation Safety

Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and clothing
can get caught in machin-
ery and cause serious per-
sonal injury. Keep loose
clothing and long hair
away from machinery.
Keep the blade guard in
the down position at all
times. Failure to do this
could result in serious
personal injury or death.
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
-28-

Basic Controls

The basic controls for the table saw are shown in
Figure 36. Setting up for a typical operation con-
sists of the following three steps:
1.
Make sure the blade tilt is correct. If it needs
to be adjusted, loosen the blade tilt lock,
turn the blade tilt handwheel, and tighten the
lock.
2.
Set the blade height approximately
than the workpiece thickness by turning the
blade height handwheel, then lock the blade
height in place by tightening the blade height
lock.
3. Adjust the fence to the desired width of cut,
then lock it in place by firmly pushing the
fence lock down until it stops.
Figure 36. Basic table saw controls.
G0605X/G0606X Extreme Series 12" Table Saw
⁄ " higher
1
4