Flange Bolt
Anti-Start
Safety Pin
Figure 31. Switch installed.
Miter Gauge
Components and Hardware Needed:
Miter Gauge ....................................................... 1
Miter Gauge Handle .......................................... 1
Flat Washer 8mm .............................................. 1
To install the miter gauge:
1.
Install the miter gauge handle and 8mm flat
washer onto the miter gauge as shown in
Figure 32.
Handle
Washer
Figure 32. Miter gauge installed.
2.
Slide the miter gauge into the miter gauge
slot to the left of the blade; or store it tempo-
rarily on the brackets near the blade angle
handwheel.
G0605X/G0606X Extreme Series 12" Table Saw
Fence Components
Components and Hardware Needed:
Fence Knob ....................................................... 1
Stop Paddle
Fence Resting Brackets .................................... 2
Flange Bolts M8-1.25 x 12 ................................. 2
To install the fence knobs, fence, and fence
resting brackets:
1.
Qty
2.
3.
Install the fence knob as shown in Figure
33.
Figure 33. Fence knob installed.
Install the fence onto the table to the right of
the blade.
Install the fence resting brackets (Figure 34)
onto the cabinet under the Outfeed Table
with two flange bolts.
Brackets
Figure 34. Fence resting brackets installed.
Qty
-25-