5.
Slide the bracket screws shown in Figure
28 into the notches on the splitter, push the
guard forward, and tighten the lock knob
(Figure 29).
Note: Make sure the clear plastic flap is
pushed toward the inside of the guard.
Figure 28. Installing blade guard on splitter.
Cover
Flap
Figure 29. Blade guard installed.
6.
Swing the covers down to guard the blade.
-24-
Screws
Notches
Lock knob
Riving Knife
You MUST install the riving knife or the splitter
and blade guard before operating the table saw.
Components and Hardware Needed:
Riving Knife ....................................................... 1
To install the riving knife:
1.
Remove the table insert, blade guard, and
splitter—if previously installed.
2.
Lift the lever (Figure 30), insert the riving
knife into the bracket slot, and turn the lever
down to secure the knife.
3.
Reinstall and secure the table insert.
Riving Knife
Lever
Figure 30. Riving knife installed.
On/Off Switch
Components and Hardware Needed:
Safety Pin .......................................................... 1
Flange Bolts M8-1.25 x 25 ................................ 2
To install the switch:
1.
Fasten the switch to the left end of the front
rail with two flange bolts, and install the anti-
start safety pin as shown in Figure 31.
G0605X/G0606X Extreme Series 12" Table Saw
Qty
Bracket
Qty