Table of Contents
Advertisement
— if the infeed fence board is already face
planed
1
⁄
" less than the outfeed fence
16
board, proceed to Step 8.
6.
Square up a second infeed fence board to the
same dimensions as the one you removed in
Step 5, then face plane off
of material removed will determine the depth
of cut.
Removing more than
fence may greatly increase the risk of kick-
back injury when routing.
7.
redrill and countersink holes in the new
infeed fence board, then secure it with the
fasteners removed in Step 5.
8.
place a straightedge against the outfeed
fence board, then adjust the fence assembly
so that the straightedge is also against the bit
flute, as illustrated in figure 30.
figure 30. Fence jointer setup (guard removed
for clarity.
Model h7507 (Mfg. since 3/05)
⁄
". the amount
1
16
⁄
" from the infeed
1
16
9.
lock the fence assembly in place, adjust the
router guard as needed and secure it, con-
nect the router to power, then perform the cut
(see figure 31).
figure 31. Edge jointing (guard removed for
clarity).
Always feed the workpiece against the rout-
er bit rotation direction, as illustrated below.
Otherwise, the workpiece could be aggres-
sively pulled from your hands, drawing
them into the spinning cutter.
-21-
Advertisement
Table of Contents
