Mounting Router - Grizzly H7507 Owner's Manual

Mounting Router

the Model h7507 will support a router with a base
thickness between ⁄ " and
1
4
To mount a router to the router table:
1.
diSConnECt SaW and routEr FroM
poWEr!
2.
Slide three of the router hold-down assem-
blies into the t-slots underneath the router
table so that they allow room for the router
base, as shown in figure 11.
hold-down Knob
t-Slots
hold down
Clamp
figure 11. router hold-down assembly controls.
Note: To properly position the hold-down
clamp, balance the tightness of the hold-
down knob and the adjustment bolt so that
the clamp will allow room for the router base
in the next step. It may be necessary to move
the jam nut on the adjustment bolt to the
other side of the hold down clamp, as shown
in Figure 12, to properly fit your router.
adjustment Bolt
thick-Base routers
figure 12. router adjustment bolt posotions.
Model h7507 (Mfg. since 3/05)
⁄ ".
3
4
adjustment Bolt
Jam nut
Jam nut
thin-Base routers
( ⁄ " or thinner)
1
2
If the router unexpectedly moves or the
router bit contacts the table insert or fence
during operation, serious personal injury
could result from flying debris. ALWAyS
make sure that at least three router clamps
are used and are applied to a flat surface
of the router base before connecting the
router to power.
3.
Slide the router base onto the three hold-
down clamps, position them so that they
secure the router bit in the center of the table
opening, then tighten the hold-down knobs
and adjustment bolts to secure the router in
place (see figure 13).
figure 13
router mounted under wing.
.
4.
install the remaining hold-down assembly to
make sure the router stays firmly in place dur-
ing avoperation.
NOTICE
Do not tighten the
clamp adjustment
bolts against the
thin edge of the
T-slots, or they may
break.
-13-