Dust Collection - Grizzly H7507 Owner's Manual

19. Center the guard over the table opening and
attach the guard assembly to the top of the
fence boards with the two provided wood
screws, as shown in figure 29.
figure 29. attaching router guard.
20. adjust the guard horizontally (if necessary)
by using the horizontal bracket slots and
wood screws.
21. adjust the height of the guard
the workpiece height by using the vertical
bracket slots and carriage bolt/wing nuts.
22. Connect the top of the guard to your dust col-
lection system with a 3" adapter.
If you change router bits, the fence pieces
must be adjusted in/out so there is not more
than ⁄ " clearance between the router bit
1
8
and the fences.
-18-
DO NOT use the Model H7507 without an ade-
quate dust collection system. An attached
router will create substantial amounts of
wood dust while operating. failure to use a
dust collection system can result in short
and long-term respiratory illness.
Recommended cfM at Dust port: 225 cfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
⁄ " higher than
1
8
the Model h7507 features a clear 3" plastic guard
that can be connected to a dust collector or a dust
collection system.

Dust collection

Model h7507 (Mfg. since 3/05)