Spray Gun Assembly - Grizzly H8225 Instruction Manual

Prior to assembly and use of the spray gun,
thoroughly clean and dry all parts. Please
Refer to Cleaning in the MAINTENANCE
section on Page 13 for more detailed
instructions.
Make sure all connections are tight enough
to prevent air leaks but not so tight as to
damage the tool.
Controls
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
Atomizing Cap
Material Hose
Figure 4. Material and air hoses attached to the spray gun.
Model H8225 2

Spray Gun Assembly

Trigger
⁄ Gallon Paint Tank with Gun
1
2
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
Pattern Control
Fluid Control
Air Hose
-7
-